Home

_________ describe(s) users that can connect to a network from any location.

A. SOHO

B. Branch office

C. Mobile users

D. Corporate office

You can do it yup
  1. A routing protocol that supports route summarization must perform all except which of the following?
  2. ___________ only translates one (and only one) IP address to another.
  3. A _________ connects two or more LANs in the same geographic area.
  4. Which of the following is true concerning full-duplexing?
  5. OSPF uses __________ as a metric.
  6. Which command is used to define the local addresses that are statically translated to global addresses?
  7. Which of the following is not true concerning TCP?
  8. _________ defines how the Frame Relay DTE and DCE interact with each other.
  9. Frames sent above the __________ limit will have their _________ bit set.
  10. The dialer map command contains all of the following parameters except __________.
  11. You are given a Class C network, 192.168.1.0/24. You need one network with 120 hostsand two networks…
  12. You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
  13. When using the show interfaces command, which Frame Relay information can you not see?
  14. An OSPF's router ID is based on __________.
  15. When examining the IP routing table, an EIGRP route will be shown as what letter?
  16. Which router command would you use to view the configuration register value?
  17. RIP has a hold-down period of ____________ seconds.
  18. Which VTP mode(s) will propagate VTP messages?
  19. The ___________ is the point where the carrier's responsibility ends and yours begins.
  20. The function of the MODE button is to __________.
  21. What command creates a DHCP address pool on a router?
  22. Which of the following is a Network layer protocol for the TCP/IP protocol stack?
  23. Which router command performs an overwrite process? (Choose all correct answers.)
  24. What uses 64 Kbps of bandwidth?
  25. Which command defines interesting traffic?
  26. The _________ reference point defines the connection between the NT2 and the NT1.
  27. _________ describe(s) users that can connect to a network from any location.
  28. When configuring a router-on-a-stick, the configuration is done on __________.
  29. An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
  30. Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________…