EIGRP uses the _________ algorithm to update its routing table.
Correct Answer :
Download Objective type questions of
Visit our PDF store
Get all objective type questions of WAN MCQ
comments powered by Disqus.
The default encapsulation on a synchronous serial interface is _________.
Which of the following is the most expensive type of WAN connection?
You are given a class C network, 192.168.1.0/24. You need one network with 120 hosts and three networks…
You are given a Class C network with 25 bits of networking. How many subnets do you have?
You have this binary value: 11000001. This equates to _____ in decimal.
The slot number of a 1900's Fast Ethernet uplink ports is ________.
What router command saves the active configuration to NVRAM?
Which of the following reasons might you need to use address translation?
Which of the following is true concerning full-duplexing?
If the 2950's RPS is ________, the external power supply is supplying power.
A ___________ is similar to a telephone circuit-switched connection.
How many steps do LCP and NCP go through when setting up a connection?
When choosing a dynamic routing protocol, which of the following should not be considered?
When a carrier experiences congestion, it marks the _______ bit in the header of the Frame Relay frame.
__________ states that if a neighboring router sends a route to a router, the receiving router will…
When setting up an RJ-45 console connection, you need a RJ-45-to-DB-9 __________ adapter to attach to…
Which frame field is different between ISO HDLC and Cisco's HDLC?
The ___________ is the point where the carrier's responsibility ends and yours begins.
Which is an example of a hybrid protocol?
Which types of memory do not maintain their contents during a power-off state?
Which of the following is a Network layer protocol for the TCP/IP protocol stack?
22.214.171.124 is a Class __________ address.
Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing…
A ___________ is basically all of the components, hardware and software, involvedin connecting computers…
A __________ topology uses a single connection to connect all devices together.
_________ negotiates the data link and network layer protocols that will traverse a PPP connection.
Which 2950 command assigns a VLAN to an interface?
Which interface type is used to connect to the serial interface of a router?
What subnet mask would you use to set up a default route?
When using the show interfaces command, which Frame Relay information can you not see?
Join our Chat Group
Join our Twitter Group
Join our Pinterest Group
Join our Facebook Group
Subscribe to our Email Newsletter