If you enter a command in either User EXEC mode or Privilege EXEC mode that the IOS does not recognize, the switch or router

A. Logs you out

B. Tries to resolve the command to an IP address

C. Executes the closest command that it can find in its command set

D. Makes a "beep" sound

You can do it yup
  1. The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a…
  2. What command creates a DHCP address pool on a router?
  3. Which of the following commands belongs on the physical interface when using dialer profiles?
  4. What subnet mask would you use to set up a default route?
  5. Which of the following is not an advantage of DHCP?
  6. ___________ defines LAPD, which is responsible for the data-link layer connection between the router…
  7. You are in Interface Subconfiguration mode and want to completely return to Privilege EXEC mode. What…
  8. RIP has a maximum hop count of ____________ hops.
  9. Which router command creates a standard named ACL called test?
  10. When choosing a WAN solution, consider all of the following except __________.
  11. Which command is used to define the local addresses that are statically translated to global addresses?
  12. Which of the following is false concerning OSPF?
  13. An OSPF's router ID is based on __________.
  14. You are given a Class C network, You need one network with 120 hostsand two networks…
  15. RIP generates routing updates every _________ seconds.
  16. Which is true concerning a port in a listening state? (Choose all correct answers.).
  17. If the 1900 SYSTEM LED is _________, a system POST test has failed.
  18. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  19. Which VTP mode(s) will propagate VTP messages?
  20. You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
  21. Which controller command specifies how ones and zeros are represented on a digital circuit?
  22. You are given a Class C network with a subnet mask of How many host addresses are there…
  23. On the 1900 switch, how do you enter User EXEC mode?
  24. A _________ routes between different autonomous systems.
  25. The address of a Frame Relay VC is called a ___________.
  26. When examining the IP routing table, an EIGRP route will be shown as what letter?
  27. Which router command would you use to view the configuration register value?
  28. Which 2950 command assigns a VLAN to an interface?
  29. Which prompt indicates that you are at User EXEC mode?
  30. Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________…