Home

The 1900 switch supports ________ VLANs.

A. 10

B. 32

C. 64

D. 250

You can do it yup
  1. A 1924 has _________ Ethernet interfaces.
  2. If the 1900 SYSTEM LED is _________, a system POST test has failed.
  3. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  4. With _________ switching, the switch reads the destination MAC address of the frame andimmediately starts…
  5. The 1900 switch supports ________ VLANs.
  6. Ethernet ___________ has/have both a physical and logical bus topology.
  7. On the 1900 switch, how do you enter User EXEC mode?
  8. Which of the following is false concerning CHAP?
  9. An _____________ is a public IP address associated with an inside device.
  10. You are given a Class C network with 25 bits of networking. How many subnets do you have?
  11. Which router command would you use to view the configuration register value?
  12. If you see a VC with an inactive status, this indicates ____________.
  13. When connecting a switch to a router, use a ___________ cable.
  14. A _________ connects two or more LANs in the same geographic area.
  15. Which IGRP command allows unequal-cost load balancing?
  16. Which type of routing protocol uses the Shortest Path First algorithm?
  17. EIGRP uses the _________ algorithm to update its routing table.
  18. When setting up an RJ-45 console connection, you need a RJ-45-to-DB-9 __________ adapter to attach to…
  19. Which router command creates a standard named ACL called test?
  20. PPP can do all of the following except ___________.
  21. A ________ topology describes how devices communicate with each other.
  22. Which Frame Relay command is used to manually resolve addresses?
  23. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  24. The dialer map command contains all of the following parameters except __________.
  25. Which of the following reasons might you need to use address translation?
  26. Which command defines interesting traffic?
  27. You are in Interface Subconfiguration mode and want to completely return to Privilege EXEC mode. What…
  28. Which prompt indicates that you are at User EXEC mode?
  29. Which of the following are classless protocols?
  30. Which is an example of a hybrid protocol?