Home

The _______ program goes out and finds the IOS and loads it.

A. ROMMON

B. Bootstrap

C. Mini-IOS

D. Loader

You can do it yup
  1. Which of the following trunking methods is/are proprietary to Cisco?
  2. Which type of traffic is not flooded?
  3. What command assigns a User EXEC password to a 2950 switch?
  4. There are _________ actions a router can take when there is a match on an ACL statement
  5. A _________ provides a high-speed infrastructure to move data between storage devices and file servers.
  6. The slot number of a 1900's Fast Ethernet uplink ports is ________.
  7. You are given the following addressing information: 10.0.8.0/22. What type of address is this?
  8. Which command takes you from Privilege EXEC mode to User EXEC mode?
  9. Which frame field is different between ISO HDLC and Cisco's HDLC?
  10. A 1924 has _________ Ethernet interfaces.
  11. The dialer map command contains all of the following parameters except __________.
  12. Which router command specifies the ISDN switch the router is connected to?
  13. Which of the following commands belongs on the physical interface when using dialer profiles?
  14. Which router-on-a-stick command defines the VLAN for the interface?
  15. 172.16.240.256 is a class __________ address.
  16. _________ describe(s) users that can connect to a network from any location.
  17. What command creates a DHCP address pool on a router?
  18. Which IGRP command allows unequal-cost load balancing?
  19. When examining the IP routing table, an EIGRP route will be shown as what letter?
  20. Which of the following WAN categories does ISDN fall under?
  21. The root switch is the one elected with the __________ __________.
  22. With a crossover cable, which pins are crossed over?
  23. The switch port that is chosen to forward traffic for a segment is called a __________.
  24. Which of the following is a Network layer protocol for the TCP/IP protocol stack?
  25. The _________ command takes you from User EXEC mode to Privilege EXEC mode
  26. Which 2950 command enables trunking?
  27. Which Frame Relay command is used to manually resolve addresses?
  28. An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
  29. When setting up an RJ-45 console connection, you need a RJ-45-to-DB-9 __________ adapter to attach to…
  30. A ___________ is basically all of the components, hardware and software, involvedin connecting computers…