What is the most convenient way of achieving large capacitance?

A. By using multiplate construction

B. By using air as dielectric

C. By decreasing distance between plates

D. By using dielectric of low permittivity

You can do it
  1. What is the total resistance of a two equal valued resistors in series?
  2. A wire of one kilometre length has a resistance of 20 . If the length is halveda then the new resistance…
  3. Which factor does not affect resistance?
  4. What is the reciprocal of capacitance?
  5. The charging of a capacitor through a resistance follows what law?
  6. What is the form factor of a triangular wave?
  7. The potential gradient in a cable is maximum in
  8. Form its definitiona the unit of electric fielda is the N/C and equivalent unit of is the
  9. If three 100-pF capacitors are connected in seriesa then the total capacitance is
  10. The area of capacitor plates increases two timesa then its capacitance
  11. What is the specific resistance of a pure silicon?
  12. Which of the following does not refer to electrical energy?
  13. When current and voltage arte in phase in an ac circuita the ___ is equal to zero.
  14. Metal tin becomes superconductor at approximately
  15. How many degrees of phase represents one full cycle?
  16. When resistance are connected in parallela the total resistance is
  17. Which statement is true?
  18. What determines the magnitude of electric current?
  19. For a triangular and sawtooth waveform the rms voltage or current equals
  20. According to Gauss theorema flux can be equated to
  21. The charging of a capacitor through a resistance obeys
  22. What is the other name of relative permittivity?
  23. The reactance curve is a plot of frequency versus _____ for a series RLCcircuit
  24. What does a capacitor store?
  25. What is the peak factor of a triangular wave?
  26. Which of the following represents the energy stored in a cap
  27. A gang capacitor is a variable capacitor in which capacitance is varied by changing the
  28. A series RL circuit has R of 10 and XL of 5 a its impedance in rectangular form is given by
  29. Loop currents should be assumed to flow in which direction
  30. A capacitor is used to