Home

What router command saves the active configuration to NVRAM?

A. copy nvram startup-config

B. copy startup-config running-config

C. copy running-config nvram

D. copy running-config startup-config

You can do it yup
  1. Which would you use to move your cursor back one word?
  2. Which of the following WAN categories does ISDN fall under?
  3. An OSPF's router ID is based on __________.
  4. When setting up an RJ-45 console connection, you need a RJ-45-to-DB-9 __________ adapter to attach to…
  5. If you enter a command in either User EXEC mode or Privilege EXEC mode that the IOS does not recognize,…
  6. What would you use to prevent a packet from traveling around a routing loop forever?
  7. The address of a Frame Relay VC is called a ___________.
  8. Which router command specifies the ISDN switch the router is connected to?
  9. Which of the following is true concerning ISL?
  10. When configuring a router-on-a-stick, the configuration is done on __________.
  11. There are _________ actions a router can take when there is a match on an ACL statement
  12. Which Frame Relay command is used to manually resolve addresses?
  13. Which of the following is true concerning 802.1Q?
  14. VLSM allows you to summarize 192.168.2.0/24 and 192.168.3.0/24 as 192.168.2.0/25.
  15. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  16. If the 2950's RPS is ________, the external power supply is supplying power.
  17. A VTP server switch generates a summary advertisement every _________ minutes.
  18. _________ allows you to create this summarization: 10.0.0.0/7.
  19. You are given the following addressing information: 10.0.8.0/22. What type of address is this?
  20. When configuring your terminal emulation software for a console connection, set the flow control to…
  21. Which router command clears all of the static translations in the address translation table?
  22. You are at User EXEC mode and type the letter e. What message appears?
  23. When you have configured PPP on an interface and use the show interfaces command, what state indicates…
  24. If you wanted a list of parameters for the show command, you would type ________.
  25. The slot number of a 1900's Fast Ethernet uplink ports is ________.
  26. Ethernet ___________ has/have both a physical and logical bus topology.
  27. When connecting a router to a PC, use a __________ cable.
  28. _________ describe(s) users that can connect to a network from any location.
  29. You have ISL trunks in your network and five VLANs configured. How many instances of STP are running?
  30. What uses 64 Kbps of bandwidth?