Home

When choosing a networking product, you should consider all of the following except _______.

A. Ease of installation and support

B. Product features and functions

C. Backplane capacity

D. Amount of memory

You can do it yup
  1. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  2. When choosing a dynamic routing protocol, which of the following should not be considered?
  3. VLSM allows you to summarize __________ back to the class boundary.
  4. Which of the following is not an advantage of route summarization?
  5. The slot number of a 1900's Fast Ethernet uplink ports is ________.
  6. An OSPF's router ID is based on __________.
  7. You are given a class C network and you have four LAN segments with the following numbers of devices:…
  8. _________ allows you to create this summarization: 10.0.0.0/7.
  9. BPDU stands for ____________.
  10. _________ defines how the Frame Relay DTE and DCE interact with each other.
  11. When a carrier experiences congestion, it marks the _______ bit in the header of the Frame Relay frame.
  12. EIGRP generates hellos every _________ seconds on LAN segments.
  13. The router automatically saves its configuration.
  14. Which 2950 command assigns a VLAN to an interface?
  15. You have this binary value: 11000001. This equates to _____ in decimal.
  16. Which is true concerning a port in a listening state? (Choose all correct answers.).
  17. Which command takes you from Privilege EXEC mode to User EXEC mode?
  18. When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt…
  19. There are _________ actions a router can take when there is a match on an ACL statement
  20. Which of the following is true concerning bridges?
  21. Which type of traffic is not flooded?
  22. Which of the following is true concerning ISL?
  23. Which frame field is different between ISO HDLC and Cisco's HDLC?
  24. A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain…
  25. The OSPF process ID is __________.
  26. Which control sequence moves the cursor to the end of the line?
  27. 172.16.240.256 is a class __________ address.
  28. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
  29. VLSM allows a network segment to have more than one subnet mask.
  30. The ___________ converts an ISDN four-wire connection to a two-wire connection.