Home

When connecting a router to a PC, use a __________ cable.

A. Crossover

B. Straight-through

C. Rollover

You can do it yup
  1. The dialer map command contains all of the following parameters except __________.
  2. You execute the line console 0 command from Configuration mode. What will the router's prompt be?
  3. A _________ routes between different autonomous systems.
  4. Which of the following commands belongs on the physical interface when using dialer profiles?
  5. A ___________ in a bit position of a wildcard mask means that the same bit position in the condition…
  6. If the 1900 SYSTEM LED is _________, a system POST test has failed.
  7. VLSM allows a network segment to have more than one subnet mask.
  8. An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
  9. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  10. The ___________ is the point where the carrier's responsibility ends and yours begins.
  11. Which metric components, by default, are used in IGRP? (Choose all the correct answers.)
  12. Which command takes you from Privilege EXEC mode to User EXEC mode?
  13. You are given a Class C network with 25 bits of networking. How many subnets do you have?
  14. A Class A address has _________ host bits.
  15. Which is not one of the three main functions of a layer-2 device?
  16. Which protocol supports VLSM?
  17. A routing protocol will use a _________ to determine which path is the best path.
  18. The _________ command takes you from User EXEC mode to Privilege EXEC mode
  19. _________ allows you to create this summarization: 10.0.0.0/7.
  20. Which interface type is used to connect to the serial interface of a router?
  21. EIGRP will route for ___________.
  22. A __________ topology uses a single connection to connect all devices together.
  23. Which router command would you use to test only layer-3 connectivity?
  24. Which control sequence moves the cursor to the end of the line?
  25. Which type of routing protocol uses the Shortest Path First algorithm?
  26. Which of the following are not features of ACLs?
  27. A routing protocol that supports route summarization must perform all except which of the following?
  28. Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________…
  29. When configuring a router-on-a-stick, the configuration is done on __________.
  30. If the port status LED on a 2950 is ________, there is a physical layer connection problem.