Which of the following are classless protocols?




D. Neither IGRP or EIGRP

You can do it yup
  1. A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain…
  2. OSPF uses __________ as a metric.
  3. When connecting a switch to a router, use a ___________ cable.
  4. An _____________ is a public IP address associated with an inside device.
  5. The TCP/IP protocol stack has ________ layers.
  6. The address of a Frame Relay VC is called a ___________.
  7. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  8. OSPF supports a ________-layer hierarchical design.
  9. IOS images can be loaded from all the following except:
  10. The root switch is the one elected with the __________ __________.
  11. Which router command creates a standard named ACL called test?
  12. Which command assigns a default gateway to the 2950 switch?
  13. EIGRP uses the _________ algorithm to update its routing table.
  14. RIP generates routing updates every _________ seconds.
  15. An OSPF's router ID is based on __________.
  16. You are given a Class C network with a subnet mask of How many host addresses are there…
  17. What would you enter to see the last few commands you entered?
  18. You are given a class C network, You need three networks with 60 hosts and two networks…
  19. A 1924 has _________ Ethernet interfaces.
  20. Which IGRP command allows unequal-cost load balancing?
  21. Which of the following is not an advantage of route summarization?
  22. You are in Interface Subconfiguration mode and want to completely return to Privilege EXEC mode. What…
  23. Extended IP ACLs should be placed as close to the ____________ device as possible.
  24. Which 2950 command enables trunking?
  25. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  26. When choosing a dynamic routing protocol, which of the following should not be considered?
  27. ________ topologies in NBMA environments do not have problems with split horizon.
  28. Which is an example of a hybrid protocol?
  29. RIP supports load balancing for up to __________ ___________ paths.
  30. Which prompt indicates that you are at User EXEC mode?