Which prompt indicates that you are at User EXEC mode?
Correct Answer :
Download Objective type questions of
Visit our PDF store
Get all objective type questions of WAN MCQ
comments powered by Disqus.
The ___________ converts an ISDN four-wire connection to a two-wire connection.
Which command takes you from Privilege EXEC mode to User EXEC mode?
___________ has both physical and logical ring topologies.
You are given a class C network, 192.168.1.0/24. You need one network with 120 hosts and three networks…
PPP can do all of the following except ___________.
A _________ is a network that provides a secure connection from a company to other business partners.
Which of the following commands belongs on the physical interface when using dialer profiles?
A _________ uses Gigabit Ethernet as a media type
The function of the MODE button is to __________.
A _________ is used to connect networking devices that are in a very close geographic area, such as…
The ___________ is the point where the carrier's responsibility ends and yours begins.
What would you use to prevent a packet from traveling around a routing loop forever?
Which router command would take you back to a suspended telnet session?
Which command activates an IP ACL on a router's interface?
You are given a Class C network, 192.168.1.0/24. You need one network with 120 hostsand two networks…
The _________ command takes you from User EXEC mode to Privilege EXEC mode
___________ defines LAPD, which is responsible for the data-link layer connection between the router…
_________ negotiates the data link and network layer protocols that will traverse a PPP connection.
Which of the following is stored in ROM? (Choose all correct answers.)
When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt…
Distance vector protocols use ___________ to disseminate routing information.
Which would you use to move your cursor back one word?
With _________ switching, the switch reads the destination MAC address of the frame andimmediately starts…
Which protocol supports VLSM?
Which IGRP command allows unequal-cost load balancing?
If the port status LED on a 2950 is ________, there is a physical layer connection problem.
A ___________ in a bit position of a wildcard mask means that the same bit position in the condition…
You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there…
What command creates a DHCP address pool on a router?
Which of the following is not an advantage of DHCP?
Join our Chat Group
Join our Twitter Group
Join our Pinterest Group
Join our Facebook Group
Subscribe to our Email Newsletter