Which protocol supports VLSM?

A. RIPv2



D. None of these

You can do it yup
  1. The dialer map command contains all of the following parameters except __________.
  2. RIP supports load balancing for up to __________ ___________ paths.
  3. PPP can do all of the following except ___________.
  4. When using the show interfaces command, which Frame Relay information can you not see?
  5. When using debug with PAP, which of the following message types might you see?
  6. _________ negotiates the data link and network layer protocols that will traverse a PPP connection.
  7. Which of the following is a Network layer protocol for the TCP/IP protocol stack?
  8. OSPF supports a ________-layer hierarchical design.
  9. If you wanted a list of parameters for the show command, you would type ________.
  10. Which of the following is not an advantage of DHCP?
  11. _________ has a physical star topology but a logical ring topology.
  12. Which of the following is a disadvantage of SANs?
  13. If you enter a command in either User EXEC mode or Privilege EXEC mode that the IOS does not recognize,…
  14. You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
  15. Which 1900 command enables port security?
  16. _________ describe(s) users working from home.
  17. Which of the following are not features of ACLs?
  18. Which of the following is true concerning 802.1Q?
  19. What command assigns a User EXEC password to a 2950 switch?
  20. The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a…
  21. The switch port that is chosen to forward traffic for a segment is called a __________.
  22. What would you enter to see the last few commands you entered?
  23. Which router command creates a standard named ACL called test?
  24. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  25. Private addressing is defined in RFC ______.
  26. OSPF uses __________ as a metric.
  27. Which of the following is true concerning full-duplexing?
  28. An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
  29. Which 2950 command assigns a VLAN to an interface?
  30. When setting up an RJ-45 console connection, you need a RJ-45-to-DB-9 __________ adapter to attach to…