Home

Which VTP mode(s) will propagate VTP messages?

A. Client and server

B. Server

C. Client, server, and transparent

D. Transparent

You can do it yup
  1. Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________…
  2. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  3. Which 1900 command enables port security?
  4. Enter the wildcard mask value to match on every bit position in an address: _________.
  5. Which of the following is false concerning OSPF?
  6. Which of the following commands belongs on the physical interface when using dialer profiles?
  7. What would you enter to see the last few commands you entered?
  8. Which Frame Relay command is used to manually resolve addresses?
  9. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  10. When choosing a networking product, you should consider all of the following except _______.
  11. Which of the following is a Network layer protocol for the TCP/IP protocol stack?
  12. You are given a Class B network with a subnet mask of 255.255.255.192. How many hostaddresses are there…
  13. The address of a Frame Relay VC is called a ___________.
  14. Which of the following is the most expensive type of WAN connection?
  15. Which is an example of a hybrid protocol?
  16. Annex A is which LMI standard?
  17. _________ negotiates the data link and network layer protocols that will traverse a PPP connection.
  18. 172.16.240.256 is a class __________ address.
  19. To recall a previous command, which of the following would you use?
  20. What uses 64 Kbps of bandwidth?
  21. Which of the following is a private address?
  22. You are given the following addressing information: 172.17.16.255/23. What type of address is this?
  23. You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks…
  24. Which is not one of the three main functions of a layer-2 device?
  25. Which metric components, by default, are used in IGRP? (Choose all the correct answers.)
  26. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  27. Which of the following is not true concerning TCP?
  28. ___________ defines LAPD, which is responsible for the data-link layer connection between the router…
  29. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
  30. You have a 24-channel T1 connection to your router. How many VCs does this T1 support?