Home

Who designed the first electronics computer ENIAC?

A. Van-Neumann

B. Joseph M. Jacquard

C. J. Presper Eckert and John W Mauchly

D. All of above

You can do it
  1. How many address lines are needed to address each machine location in a 2048 x 4 memory chip?
  2. The device used to carry digital data on analogue lines is called as
  3. A computer program that converts an entire program into machine language is called a/an
  4. Which is not a computer classification?
  5. John Napier invented Logarithm in
  6. A computer system that is old and perhaps not satisfactory is referred to as a(n)
  7. The first generation of computers available was based on the bit micro processors.
  8. A computer has very low failure rate because it uses electronic components. It produces very consistent…
  9. Which is used for manufacturing chips?
  10. Which of the following processors use RISC technology?
  11. Who is the father of Computer science?
  12. The most commonly used standard data code to represent alphabetical, numerical and punctuation characters…
  13. Before a disk drive can access any sector record, a computer program has to provide the record's disk…
  14. The Width of a processor's data path is measured in bits. Which of the following are common data paths?
  15. Floppy disks typically in diameter
  16. While inserting a diskette into the diskette drive of a PC, the diskette's label side should face
  17. VGA is
  18. Which of the following is not an output device?
  19. Which is considered a direct entry input device?
  20. Which converts the user data into machine readable form?
  21. Compilers and interpreters are themselves
  22. Easily reloctable language is
  23. Access time is
  24. The Third Generation Computer was made with .
  25. The terminal device that functions as a cash register, computer terminal, and OCR reader is the:
  26. A modem is connected to
  27. Current SIMMs have either or connectors (pins)
  28. A memory that does not change its contents without external causes is known as
  29. The microcomputer, Intel MCS-80 is based on the widely used Intel
  30. FORTRAN programming language is more suitable for ____