With _________ switching, the switch reads the destination MAC address of the frame and
immediately starts forwarding the frame.

A. Store-and-forward

B. Cut-through

C. Fragment-free

D. Runtless

You can do it yup
  1. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  2. Which Frame Relay command is used to manually resolve addresses?
  3. You are given a class C network, You need one network with 120 hosts and three networks…
  4. The default encapsulation on a synchronous serial interface is _________.
  5. _________ is/are a routed protocol.
  6. You are given a Class C network with a subnet mask of How many host addresses are there…
  7. Which of the following is true concerning RIPv2?
  8. Which of the following is false concerning VLANs?
  9. Which of the following is true concerning 802.1Q?
  10. What subnet mask would you use to set up a default route?
  11. Which type of traffic is not flooded?
  12. Which of the following WAN categories does ISDN fall under?
  13. Which of the following are classless protocols?
  14. OSPF supports a ________-layer hierarchical design.
  15. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  16. Which router command would take you back to a suspended telnet session?
  17. When connecting a switch to a router, use a ___________ cable.
  18. Which router command creates a standard named ACL called test?
  19. To recall a previous command, which of the following would you use?
  20. Which VTP mode(s) will propagate VTP messages?
  21. Which 1900 command enables port security?
  22. Which protocol supports VLSM?
  23. __________ allows you to distribute connection requests destined to a single IP address to multiple…
  24. Which type of traffic is sent to a group of devices?
  25. OSPF uses __________ as a metric.
  26. Which router command performs an overwrite process? (Choose all correct answers.)
  27. A __________ topology uses a single connection to connect all devices together.
  28. There are _________ actions a router can take when there is a match on an ACL statement
  29. The _______ program goes out and finds the IOS and loads it.
  30. Which of the following is false concerning OSPF?