Home

You are given a Class C network with 25 bits of networking. How many subnets do you have?

A. 1

B. 2

C. 3

D. 4

You can do it yup
  1. Which of the following situations are best for DDR connections?
  2. Which of the following is a valid subnet mask value?
  3. If you wanted a list of parameters for the show command, you would type ________.
  4. If you enter a command in either User EXEC mode or Privilege EXEC mode that the IOS does not recognize,…
  5. Ethernet ___________ has/have both a physical and logical bus topology.
  6. The dialer map command contains all of the following parameters except __________.
  7. Enter the wildcard mask value to match on every bit position in an address: _________.
  8. OSPF supports a ________-layer hierarchical design.
  9. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  10. Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing…
  11. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  12. Extended traceroute works from which mode?
  13. You have ISL trunks in your network and five VLANs configured. How many instances of STP are running?
  14. The switch port that is chosen to forward traffic for a segment is called a __________.
  15. A 1924 has _________ Ethernet interfaces.
  16. You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
  17. You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
  18. A __________ topology uses a single connection to connect all devices together.
  19. A __________ route is the best path to reach a destination within the topology table.
  20. Which control sequence moves the cursor to the end of the line?
  21. An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
  22. Which of the following is stored in ROM? (Choose all correct answers.)
  23. When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt…
  24. The TCP/IP protocol stack has ________ layers.
  25. Which interface type is used to connect to the serial interface of a router?
  26. Annex A is which LMI standard?
  27. Which router command clears all of the static translations in the address translation table?
  28. A _________ is a network that provides a secure connection from a company to other business partners.
  29. Extended IP ACLs should be placed as close to the ____________ device as possible.
  30. You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks…